|
|
01-25-2023, 06:07 PM
|
#1 |
|
Member
Join Date: Feb 2008
Location: Great Plains, USA
Posts: 286
|
Is this too tight of a bleed for die-cut?
I made a custom die-cut sticker design but realized it needs a 1/8" bleed so the artwork doesn't get clipped off. I added a thin black outline to the whole design, with a bleed extended out of that, but I realize the inner outline I intend to keep in the finished piece is awfully small (see files). The final design is about 5" wide.
Thoughts? |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Uuuugh....can't see bleed lines | XOatWoodMaxx | Print Design | 4 | 01-04-2013 02:07 PM |
| Maximum Bleed for 8.5"x11" Sheet? | Ronald | Print Design | 5 | 09-21-2010 03:08 PM |
| ID CS2 margin/bleed errors in PDF | belmontny | Print Design | 0 | 07-09-2006 11:15 PM |
Threaded Mode